The Gas Turbine Research Establishment (GTRE) of Bangalore, India is a government laboratory whose primary function is research and development of marine and aeronautic gas turbines. Development of GTRE’s flagship product, the Kaveri jet engine, was commissioned for the all-terrain HAL Tejas aircraft.
One of the greatest challenges in designing the Kaveri was positioning its many piping runs and line replaceable units (LRUs) on the outside of the aircraft. Many of the LRUs are connected to the interior of the engine with pipes that carry hydraulic fluid, fuel, and lubricants.
It was a major challenge to design each piping run to minimise length –and thus weight and cost - while avoiding clashes. The initial piping layout was created in CAD, but CAD alone can’t portray the complex intertwined piping non-ambiguously to all the developers. GTRE director, Dr U. Chandrasekhar takes up the story.
“The virtual environment cannot represent the design to the level that we need to meet our requirements. The computer comes close, but close isn’t good enough when you are about to make a decision to invest tens of millions of dollars to bring a new product to market.”
Building an engineering prototype is easier said than done. There are approximately 2,500 engine components that had to be included in the assembly. In the past, GTRE would have considered building the prototype using CNC machining. However, using these methods, it would have taken a minimum of one year and cost an estimated $60,000 to build the physical prototype assembly.
GTRE also considered stereolithography, but the project was not well-suited for this prototyping method due to excessive supports needed for components like turbine blades, combustor swirlers, inlet guide vanes and combustors. GTRE also realised that most conventional rapid prototyping methods would have made it necessary to produce solid pipes which would have eliminated the possibility of flow testing. Dr.Chandrasekhar turned to fused deposition modelling (FDM).
“FDM technology provided the ideal solution because the supports and interior of hollow components can be easily dissolved in a water-based solution. It allowed us to create the geometry we needed. FDM was also much faster [than traditional means] because it is possible to combine several parts into assemblies, which can be produced in a single run.”
FDM also creates parts from real engineering thermoplastics, such as ABS, which enabled GTRE to make high-strength, durable components for the project.
With over 2,500 FDM components, the Kaveri jet engine prototype may well be the most complex rapid-prototype assembly ever created. It took GTRE only 30 days to produce all these components from ABS plastic using two FDM-based Stratasys Fortus machines. It took another ten days to assemble the engine. The total cost to produce the FDM assembly was about $20,000.
The FDM assembly allowed the design and manufacturing teams to better understand how the engine components would need to fit together during manufacturing. In addition, the prototype enabled a number of GTRE’s partners, including the Indian Air Force, to better understand the engine. The net result was a lighter engine that took less time to validate and build. Dr. Chandrasekhar summarises:
“With FDM we created an engineering prototype that perfectly reflected our design intent and facilitated the complex engine development. It enabled engineers to identify and resolve problems that would have been easy to miss with only the computer model.”